Most people notice their dryer struggling in January and assume it finally gave up. The duct has usually been filling for a while, and winter is simply the season that pushes it past the point where you notice.
Three things change when it gets cold, and they compound.
1. Warm wet air meets a cold duct
A dryer pushes hot, very humid air into a duct that may run through an unheated basement, a crawlspace, an exterior wall or up to a roof.
In summer that duct is roughly room temperature and the moisture stays as vapor all the way out. In winter the metal is cold, and moisture condenses on the inside surface.
Damp duct walls hold lint instead of letting it pass. What would have blown out in July sticks in January, and each cycle adds to it.
This is why the same house with the same laundry habits loads its duct faster in winter than in summer.
2. The laundry itself gets heavier
Winter washing is towels, bedding, sweatshirts, fleece and heavy cotton. All of it sheds considerably more than the shirts and light clothing of summer.
Fleece is the worst offender and the one people forget. A few fleece blankets through a dryer produce a surprising amount of fine lint.
Volume goes up too. Fewer things dry on a line or a rack, so more goes through the machine.
3. The exterior hood has more to deal with
The vent flap outside has to open against the airflow and fall shut afterwards. In cold weather two things interfere.
Condensation around the hood can freeze, and a flap frozen part open or part shut restricts the air either way. And a warm, sheltered vent hood is attractive to animals looking for somewhere out of the weather, which blocks it the same way packed lint does.
Neither is visible from inside the house. The only symptom is a dryer taking longer.
What the combination produces
A duct that was coping in October can be genuinely restricted by January. The pattern people describe is a sudden failure, but what actually happened is a gradual load crossing a threshold.
The consequences matter more in winter too. A restricted duct makes the machine run hotter and longer, and the US Fire Administration identifies failure to clean as the leading contributing factor in clothes dryer fires. Winter is when dryers work hardest.
What to check before it gets cold
October and November are the sensible months for this, which is the practical reason for mentioning it now.
- Time a normal load. Write the number down. That gives you something to compare against in February.
- Clear the lint screen every load, and wash it with warm soapy water if you use dryer sheets. A residue builds up that you cannot see, and water should pass straight through the mesh rather than pooling on it.
- Pull the machine out and check the flexible connector for kinks and crushing.
- Run the dryer and feel for air at the outside hood. Check the flap opens freely while the machine runs.
- Look for lint on the floor behind the dryer, which points at a loose connection.
Do not go on the roof to check a cap. That applies all year and doubly on a cold morning.
The runs that suffer most
Length and layout decide how much the winter effect matters.
A short run straight out a nearby wall has very little cold duct for moisture to condense on. A long run through an unheated basement, or a vertical run up to a roof, has a great deal.
Residential code caps a dryer exhaust at 35 feet of developed length, with each 90 degree bend using about five feet of that allowance. A run near or over that limit struggles in any season and struggles more in winter. How to measure your own walks through it.
Older housing across Silver Spring and Montgomery County is full of retrofitted runs that were routed wherever there was space rather than along a short path, which is why this comes up here more than it might elsewhere.
Getting it done before the cold
More Fresh Air Services cleans dryer vents across Silver Spring, Washington DC, Maryland and Northern Virginia, with HEPA filtered vacuums and rotary brushes, and has done since 2015. We inspect the system, explain what we find, and confirm the scope before any work begins. Estimates are free.
Mention where your vent exits when you call, since that changes how the job is planned. If you do not know, say so. Working it out is part of the inspection.
See dryer vent cleaning in Silver Spring or how often yours actually needs doing.
Call 888-509-3828 or request an estimate. Open Monday to Friday from 8:00 AM to 6:00 PM, and Saturday and Sunday from 9:00 AM to 4:00 PM.
Sources: International Code Council, 2021 International Residential Code, Chapter 15 (Section M1502); U.S. Fire Administration, Clothes Dryer Fires in Residential Buildings.