Search this question and you get one answer: once a year. It is a reasonable starting point and it is wrong for a lot of houses in both directions.
A duct fills at a rate set by how much lint goes in and how easily air carries it out. Change either and the interval changes. Two identical houses on the same block can genuinely be on different schedules.
Here is what actually moves it.
1. How many loads you run
This is the biggest single factor and the most obvious. A household of five doing ten loads a week puts roughly five times as much lint through the duct as a couple doing two.
If you are trying to translate the once a year advice to your own house, start here. Heavy use can mean twice a year. Light use in a short straight run can mean considerably longer.
2. How long the run is and how many bends
Lint stays suspended while air moves quickly and drops out when it slows. Length and bends both slow the air.
Residential code allows a maximum developed length of 35 feet, with each 90 degree bend counting for about 5 feet of that. A run at 30 feet with four elbows collects far faster than a 10 foot straight shot, with the same laundry.
This is why the interval is a property question as much as a habit question.
3. What the duct is made of
Smooth rigid metal duct lets lint pass. Ribbed flexible duct catches it on every corrugation.
A long concealed run in flexible duct will need attention much more often than the same length in rigid pipe, and that is a reason to ask what you have rather than assuming.
4. What you dry
Towels, bedding, fleece and new cotton shed heavily. Synthetics shed less. A household that washes a lot of towels and bedding generates noticeably more lint than one mostly drying shirts and trousers.
Pet bedding is the extreme version. Hair and dander go through the system along with fabric fiber and build up faster than clothing alone.
5. Where the duct exits
A side wall hood at eye level is easy for air to leave and easy for you to inspect.
A roof cap is neither. Vertical runs collect at the lowest elbow, and roof terminations are exposed to weather and to nesting. It happens, particularly during nesting season, and nesting material in the hood blocks airflow the same way packed lint does.
Roof exits generally want checking more often than wall exits, mostly because nothing about them is visible from inside the house.
6. Whether the machine is vented or ventless
Worth stating because it changes the answer completely. Condensing and heat pump dryers, which are increasingly common in condos, have no exhaust duct at all. They have a condensate system and a secondary filter instead, both of which need their own maintenance, and no amount of duct cleaning applies.
If you are not sure which you have, look for a duct going into the wall behind the machine. No duct means ventless.
Forget the calendar, watch the symptom
The reliable signal is not a date. It is drying time.
Note how long a normal load takes today. If that number creeps up by a third, something has changed in the path. That is a better trigger than any annual reminder, because it responds to your actual house rather than an average.
The others worth acting on: the machine feels hotter than it used to, the laundry room gets humid during a cycle, lint appears on the floor behind the dryer, or you cannot feel strong air at the outside hood while the dryer runs.
Why not to let it drift
The US Fire Administration reports that clothes dryers are involved in thousands of residential fires every year, and identifies failure to clean as the leading cause. That is the reason the question has a real answer rather than being a matter of preference.
There is a cost argument too. A load that needs two cycles uses twice the energy of one that does not, every time, for as long as you leave it.
A practical rule
If you want one sentence: check the symptoms every few months, and if your run is long, bent, flexible or roof terminated, assume you are on a shorter interval than the house with the dryer against the back wall.
If you want it looked at, we inspect first and explain what we find before any work is agreed. More Fresh Air Services covers Washington DC, Maryland and Northern Virginia, including Silver Spring and Baltimore.
Not sure whether the problem is the duct or the appliance? Four checks that tell you.
Call 888-509-3828 or request an estimate. We are insured and registered, and open Monday to Friday from 8:00 AM to 6:00 PM, and Saturday and Sunday from 9:00 AM to 4:00 PM.
Sources: International Code Council, 2021 International Residential Code, Chapter 15 (Section M1502); U.S. Fire Administration, Clothes Dryer Fires in Residential Buildings.