Your clothes come out damp after a full cycle. In a house, that usually means lint has narrowed the pipe between the dryer and the outside wall. In a condo or an apartment building, the same symptom often has a different cause, because the air has much further to travel and the pipe is rarely yours alone.
Downtown Silver Spring has a lot of this housing. The buildings along Georgia Avenue, Colesville Road and Wayne Avenue put laundry in a closet or a corner of the kitchen, and the exhaust line disappears into a wall or a ceiling instead of running two feet to the outside.
Your vent probably does not go straight outside
In a detached house the dryer usually sits against an exterior wall. The run is short and you can often see where it ends from the yard.
In a mid rise or high rise, the dryer may be in the middle of the unit. The exhaust has to reach an exterior wall or a roof, which can mean twenty or thirty feet of duct inside walls, ceilings and chases, with several bends along the way.
Every bend slows the air and gives lint somewhere to settle. A run with four elbows collects faster than a straight one of the same length, which is why two units in the same building can be on very different schedules.
Stacked and shared exhaust systems
Some buildings give each unit its own line to the outside. Others connect several units into one shared riser that runs up through the building to a fan on the roof.
Shared systems change the picture in two ways. A blockage further up the riser can affect units that are nowhere near it, so the problem may not be in your apartment at all. And because the duct is shared property, the work usually has to be arranged through the building rather than by one resident.
Buildings with a rooftop booster fan have another point of failure. If the fan is not running, every dryer connected to it will dry slowly no matter how clean the individual connections are.
What you can check from inside your unit
There is a short list worth working through before you call anyone.
- Clear the lint screen. Do it every load, not every few weeks.
- Pull the dryer out a few inches and look at the flexible hose behind it. A crushed or kinked hose is one of the most common causes of slow drying and it is often created by pushing the dryer back too far.
- Run the dryer and put your hand near the back. If the machine feels much hotter than it used to, air is not leaving properly.
- Check how long the cycle takes compared with six months ago. A gradual slide from one cycle to two is the pattern worth paying attention to.
- Look at the floor behind the machine. Lint collecting there suggests a loose connection.
If all of that is clean and the clothes still come out damp, the restriction is somewhere you cannot reach from inside the unit. If the hose behind the dryer is crushed or has come apart, that is a dryer vent repair job rather than a cleaning.
Who to ask before booking
In a condo, the line between what you own and what the association owns is set by the building documents, and it varies. In some buildings the duct inside your walls is yours and the riser is common property. In others the whole run is common property.
Start by asking your management office two questions. Does the building maintain the dryer exhaust system, and is the duct from my unit shared with other units? The answers decide whether this is your job or theirs, and they save you paying for work the association was going to do anyway.
If you are renting, raise it with the landlord or the management office first. Slow drying caused by a blocked exhaust is a building maintenance issue in most leases. Our guide on who is responsible for dryer vent cleaning in a rental covers this in more detail.
Why it matters beyond the laundry
Lint is highly flammable and a dryer pushes warm air through it every cycle. The US Fire Administration reports that clothes dryers are involved in thousands of home fires each year, and that failure to clean them is the leading cause. In a multi unit building the consequences are shared, which is why many associations treat exhaust maintenance as a scheduled item rather than a complaint driven one.
Slow drying also costs money. Running two cycles instead of one doubles the energy a load uses, and in a building where laundry is in the unit that lands on your bill.
Getting it looked at
More Fresh Air Services cleans dryer vents across Silver Spring, including condominium and apartment buildings. Tell us the building when you call. Shared and stacked exhaust systems sometimes need management approval before work starts, and access to the connection can be limited, so it helps to know what we are dealing with before we arrive.
We are insured and fully registered. If you want the detail on what the work covers, see our dryer vent cleaning in Silver Spring page. If you are not sure whether the problem is the vent or the machine, the checks you can do yourself are a good place to start.
Call 888-509-3828 or request an estimate. We are open Monday to Friday from 8:00 AM to 6:00 PM, and Saturday and Sunday from 9:00 AM to 4:00 PM.
Source: U.S. Fire Administration, Clothes Dryer Fires in Residential Buildings.